Improvement of machining accuracy by fuzzy logic at corner parts for wire-EDM

Author： Lin C.-T.   Chung I.-F.   Huang S.-Y.  

Publisher： Elsevier

ISSN： 0165-0114

Source： Fuzzy Sets and Systems, Vol.122, Iss.3, 2001-09, pp. : 499-511

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Fuzzy logic or Lukasiewicz logic: A clarification

By Kundu S.   Jianhua C.  

Fuzzy Sets and Systems, Vol. 95, Iss. 3, 1998-05 ,pp. : 369-379

Elsevier

Access to resources Recommend Favorite

Experimental Research of Effects of Electric Parameters on the Machining Speed and Surface Quality in EDM

By  

Materials Science Forum, Vol. 2017, Iss. 893, 2017-05 ,pp. : 257-261

Trans Tech Publications

Access to resources Recommend Favorite

Surface Topography and Kerf Study of Nimonic 80A Using Wire-Cut EDM

By  

Materials Science Forum, Vol. 2014, Iss. 808, 2015-02 ,pp. : 35-41

Trans Tech Publications

Access to resources Recommend Favorite

Fuzzy logic in measurements

By Ishikawa S.  

Fuzzy Sets and Systems, Vol. 100, Iss. 1, 1998-11 ,pp. : 291-300

Elsevier

Access to resources Recommend Favorite

Attention to time in fuzzy logic

By Virant J.   Zimic N.  

Fuzzy Sets and Systems, Vol. 82, Iss. 1, 1996-08 ,pp. : 39-49

Elsevier

Access to resources Recommend Favorite