Predicting springback in sheet metal forming: an explicit to implicit sequential solution procedure - a process to reduce sidewall curl springback in high-strength steel rails

Author： Narasimhan N.   Lovell M.  

Publisher： Elsevier

ISSN： 0168-874X

Source： Finite Elements in Analysis and Design, Vol.33, Iss.1, 1999-08, pp. : 29-42

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

A reliability study of springback on the sheet metal forming process under probabilistic variation of prestrain and blank holder force

By Mrad Hatem   Bouazara Mohamed   Aryanpour Gholamreza  

Acta Mechanica Sinica, Vol. 29, Iss. 4, 2013-08 ,pp. : 557-566

Springer Publishing Company

Access to resources Recommend Favorite

Bifurcation Instability of sheet metal during spring-back

By Kim Jong-Bong  

Philosophical Magazine, Vol. 93, Iss. 15, 2013-05 ,pp. : 1914-1935

Taylor & Francis Ltd

Access to resources Recommend Favorite

Comparison of the Microstructural Effects between the BH Steel Obtained from Heat Treatment and the IF Steel of High Strength Concerning the Springback Effect

By  

Materials Science Forum, Vol. 2014, Iss. 805, 2015-01 ,pp. : 215-220

Trans Tech Publications

Access to resources Recommend Favorite

Effects of Hardening Models on CUO Forming and Springback Simulation of High Strength Line Pipes

By  

Materials Science Forum, Vol. 2015, Iss. 817, 2015-05 ,pp. : 8-13

Trans Tech Publications

Access to resources Recommend Favorite

Investigating the Influence of Bending Parameters on the Springback Behavior of Ultra-High Strength Spring Strips

By  

Materials Science Forum, Vol. 2018, Iss. 918, 2018-05 ,pp. : 125-133

Trans Tech Publications

Access to resources Recommend Favorite