Basics of machining methods to yield wear- and fretting-resistive surfaces, having regular roughness patterns

Author： Bulatov V.P.   Krasny V.A.   Schneider Y.G.  

Publisher： Elsevier

ISSN： 0043-1648

Source： Wear, Vol.208, Iss.1, 1997-07, pp. : 132-137

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Characterisation of the fretting wear of unlubricated steel surfaces based on the comparison of wear results obtained by different methods

By de Baets P.   Strijckmans K.   van Peteghem A.P.  

Wear, Vol. 208, Iss. 1, 1997-07 ,pp. : 169-176

Elsevier

Access to resources Recommend Favorite

The Effect of Cutting Speed and Feed Rate on Surface Roughness and Tool Wear when Machining Machining D2 Steel

By  

Materials Science Forum, Vol. 2017, Iss. 909, 2017-12 ,pp. : 80-85

Trans Tech Publications

Access to resources Recommend Favorite

Experimental study by means of thin layer activation of the humidity influence on the fretting wear of steel surfaces

By van Peteghem A.P.   Strijckmans K.   Kalacska G.   de Baets P.   van de Velde F.  

Wear, Vol. 216, Iss. 2, 1998-04 ,pp. : 131-137

Elsevier

Access to resources Recommend Favorite

The effect of magnetic field on fretting wear

By Sato K.   Stolarski T.A.   Iida Y.  

Wear, Vol. 241, Iss. 1, 2000-06 ,pp. : 99-108

Elsevier

Access to resources Recommend Favorite

Fretting wear of laterally supported tube

By Kim H.-K.   Kim S.   Yoon K.   Kang H.   Song K.  

Wear, Vol. 250, Iss. 1, 2001-10 ,pp. : 535-543

Elsevier

Access to resources Recommend Favorite