Research on a Numerical Schemes for Capturing Free Front during Injection Molding

Author： Zheng S.   Ouyang J.   Zhang L.   Zhao Z.  

Publisher： Taylor & Francis Ltd

ISSN： 0360-2559

Source： Polymer-Plastics Technology and Engineering, Vol.48, Iss.4, 2009-04, pp. : 446-454

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Numerical simulation of two-dimensional wick debinding in metal powder injection molding

By Chang Chih-Yuan  

Advanced Powder Technology, Vol. 14, Iss. 2, 2003-06 ,pp. : 177-194

VSP

Access to resources Recommend Favorite

Numerical Simulations and Verifications of Cyclic and Transient Temperature Variations in Injection Molding Process

By Li Hai-Mei  

Polymer-Plastics Technology and Engineering, Vol. 48, Iss. 1, 2009-01 ,pp. : 1-9

Taylor & Francis Ltd

Access to resources Recommend Favorite

Cavity Pressure Response and Melt Flow Length During Dynamic Injection Molding

By Hong-wu Wu   hai-hang Xu   Jin-ping Qu   Shao-dan Zhang  

Polymer-Plastics Technology and Engineering, Vol. 45, Iss. 8, 2006-01 ,pp. : 935-937

Taylor & Francis Ltd

Access to resources Recommend Favorite

Adhesion of nylon-6 to triazine trithiol-treated metals during injection molding

By Mori Kunio   Sasaki Hideyuki   Kobayashi Ichiro   Sai Seichi   Hirahara Hidetoshi   Oishi Yoshiyuki  

Journal of Adhesion Science and Technology, Vol. 14, Iss. 6, 2000-03 ,pp. : 791-803

Taylor & Francis Ltd

Access to resources Recommend Favorite

Measurement and Analysis of Cavity Pressure and Melt Filling Capacity During Injection Molding

By Hong-wu Wu   Shao-dan Zhang   Jin-ping Qu   Hai-hang Xu  

Polymer-Plastics Technology and Engineering, Vol. 46, Iss. 2, 2007-02 ,pp. : 123-127

Taylor & Francis Ltd

Access to resources Recommend Favorite