Author: Evin Duygu Gul Hasan Tanyıldızı Vedat
Publisher: Taylor & Francis Ltd
ISSN: 0737-3937
Source: Drying Technology, Vol.26, Iss.12, 2008-12, pp. : 1577-1583
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.
Abstract
In this study, grain drying in a spherical-based spouted bed (SBSB), a cone-based spouted bed (CBSB), and a paraboloid-based spouted bed (PBSB) with and without draft tube was investigated. Spouted-bed bases with the same volume in different shapes—spherical, cone, and paraboloid—were used for the drying experiments to investigate the effect of the spouted-bed base shape on drying. The drying experiments were carried out with perforated and solid draft tubes. The effects of the distance between the gas inlet nozzle and the bottom of the draft tube (entrainment zone height) and the draft tube diameter as geometric parameters on drying were also investigated. It was seen that the geometrical shape of the contactor base influenced the drying time. The highest drying rate was achieved for drying in a paraboloid-based spouted bed. The results also showed that using a draft tube caused a significant increase in drying time. Because the perforated draft tube allows a higher gas flow rate through the annulus, it decreases the drying time when compared with the solid draft tube. Drying time decreased slightly with the decreasing height of the entrainment zone but draft tube diameter did not have a considerable effect on drying.
Related content
Simulation of the Hydrodynamics and Drying in a Spouted Bed Dryer
Drying Technology, Vol. 25, Iss. 1, 2007-01 ,pp. :
Moisture Prediction During Paste Drying in a Spouted Bed
By Nascimento B. S. Freire F. B. Freire J. T.
Drying Technology, Vol. 31, Iss. 15, 2013-11 ,pp. :