Evaluation of Machining Parameters of Hot Turning of Stainless Steel (Type 316) by Applying ANN and RSM

Author： Ranganathan S.  

Publisher： Taylor & Francis Ltd

ISSN： 1042-6914

Source： Materials and Manufacturing Processes, Vol.25, Iss.10, 2010-10, pp. : 1131-1141

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Failure analysis of a T-joint of AISI type 316 L stainless steel

By Shaikh H.   Khatak H.S.   Mahendran N.   Sethi V.K.  

Engineering Failure Analysis, Vol. 10, Iss. 1, 2003-02 ,pp. : 113-118

Elsevier

Access to resources Recommend Favorite

Wear Analysis of ZTA-MgO Ceramic Cutting Inserts on Stainless Steel 316L Machining

By  

Advanced Materials Research, Vol. 2015, Iss. 1087, 2015-03 ,pp. : 101-105

Trans Tech Publications

Access to resources Recommend Favorite

Optimization of Tool Wear Using Coupled RSM-GA Approach in Turning of Stainless Steel AISI 304 with Magnetic Damping of Tool Shank

By  

Advanced Materials Research, Vol. 2015, Iss. 1115, 2015-08 ,pp. : 117-121

Trans Tech Publications

Access to resources Recommend Favorite

Magnetic Damping in Turning of Stainless Steel AISI 304 for the Reduction of Machining Vibration and Tool Wear

By  

Advanced Materials Research, Vol. 2015, Iss. 1115, 2015-08 ,pp. : 100-103

Trans Tech Publications

Access to resources Recommend Favorite

Influences of Austenitization Parameters on Properties of Martensitic Stainless Steel in Hot Stamping

By  

Advanced Materials Research, Vol. 2014, Iss. 1063, 2015-01 ,pp. : 194-197

Trans Tech Publications

Access to resources Recommend Favorite