A FINITE ELEMENT ANALYSIS OF BURR FORMATION IN FACE MILLING OF A CAST ALUMINUM ALLOY

Author： Sartkulvanich Partchapol   Sahlan Hakan   Altan Taylan  

Publisher： Taylor & Francis Ltd

ISSN： 1091-0344

Source： Machining Science and Technology, Vol.11, Iss.2, 2007-04, pp. : 157-181

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Experimental Investigation and Finite Element Analysis of Milling of Ti-6Al-4V Titanium Alloy by Studying Cutting Forces and Chip Microstructure

By  

Applied Mechanics and Materials, Vol. 2016, Iss. 852, 2016-10 ,pp. : 311-316

Trans Tech Publications

Access to resources Recommend Favorite

ON CHIP FORMATION DURING DRILLING OF CAST ALUMINUM ALLOYS

By Kouam Jules   Songmene Victor   Zedan Yasser   Djebara AbdelHakim   Khettabi Riad  

Machining Science and Technology, Vol. 17, Iss. 2, 2013-04 ,pp. : 228-245

Taylor & Francis Ltd

Access to resources Recommend Favorite

Finite Element Analysis and Experimental Investigation of Drilling of Titanium Alloy (Ti6Al4V)

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 813, 2015-12 ,pp. : 342-346

Trans Tech Publications

Access to resources Recommend Favorite

Finite Element Analysis and Simulation of Al 7075 Alloy Joints Produced by Friction Stir Welding

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 766, 2015-07 ,pp. : 1116-1120

Trans Tech Publications

Access to resources Recommend Favorite

Optimization of Cutting Parameters for Face Milling of Cast Iron by Reducing Specific Cutting Energy and Machined Surface Roughness

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 727, 2015-03 ,pp. : 339-344

Trans Tech Publications

Access to resources Recommend Favorite