COMPARISON OF MACHINED SURFACE QUALITY OBTAINED BY HIGH-SPEED MACHINING AND CONVENTIONAL TURNING

Author： Ekinovic Sabahudin Begovic Edin Silajdzija Amira

ISSN： 1091-0344

Source： Machining Science and Technology, Vol.11, Iss.4, 2007-10, pp. : 531-551

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Analysis of Cutting Parameters Influence on the Machined Surface Roughness Obtained by Turning of a Heat Treated Bearing Steel

Applied Mechanics and Materials, Vol. 2015, Iss. 809, 2015-12 ,pp. : 195-200

Trans Tech Publications

Access to resources Recommend Favorite

Case representation and similarity in high-speed machining

By Wang Z. Liu Z. Ai X.

International Journal of Machine Tools and Manufacture, Vol. 43, Iss. 13, 2003-10 ,pp. : 1347-1353

Elsevier

Access to resources Recommend Favorite

ON THE QUALITY OF MACHINED SURFACE REGION WHEN TURNING Al/SiC METAL MATRIX COMPOSITES

By Sadat Abdul

Machining Science and Technology, Vol. 13, Iss. 3, 2009-07 ,pp. : 338-355

Taylor & Francis Ltd

Access to resources Recommend Favorite

MECHANISM OF CHIP FORMATION IN HIGH-SPEED TURNING OF INCONEL 718

By Pawade R. S. Joshi Suhas

Machining Science and Technology, Vol. 15, Iss. 1, 2011-01 ,pp. : 132-152

Taylor & Francis Ltd

Access to resources Recommend Favorite

INVESTIGATION OF NANO-STRUCTURED PVD COATINGS FOR DRY HIGH-SPEED MACHINING

By Ning Li

Machining Science and Technology, Vol. 11, Iss. 1, 2007-01 ,pp. : 45-59

Taylor & Francis Ltd

Access to resources Recommend Favorite