ON THE QUALITY OF MACHINED SURFACE REGION WHEN TURNING Al/SiC METAL MATRIX COMPOSITES

Author： Sadat Abdul  

Publisher： Taylor & Francis Ltd

ISSN： 1091-0344

Source： Machining Science and Technology, Vol.13, Iss.3, 2009-07, pp. : 338-355

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Effect of Volume Fraction on Surface Roughness in Turning of Hybrid Metal Matrix (A6061 A1+SiC+Graphite) Composites

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 766, 2015-07 ,pp. : 263-268

Trans Tech Publications

Access to resources Recommend Favorite

Mechanical and Morphological Studies of Al6061-Gr-SiC Hybrid Metal Matrix Composites

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 813, 2015-12 ,pp. : 195-202

Trans Tech Publications

Access to resources Recommend Favorite

Roughness Analysis of the Holes Drilled on Al / SiC Metal Matrix Composites Using Atomic Force Microscope

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 766, 2015-07 ,pp. : 837-843

Trans Tech Publications

Access to resources Recommend Favorite

Tribological Behaviour of Hybrid (Al356 + SiC + Gr) Metal Matrix Composites

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 766, 2015-07 ,pp. : 269-275

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Magnesium Addition on Processing the Al-0.8 Mg-0.7 Si/SiCp Metal Matrix Composites

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 787, 2015-09 ,pp. : 553-557

Trans Tech Publications

Access to resources Recommend Favorite