Author： JAIN SHAILENDRA KUMAR
Publisher： Taylor & Francis Ltd
ISSN： 1532-5016
Source： Electric Power Components and Systems, Vol.31, Iss.7, 2003-07, pp. : 671-692
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.
Abstract
This paper presents complete design, simulation, and experimental investigations on a 3-phase shunt active power filter to compensate harmonics and the reactive power requirement of nonlinear loads. The paper describes the complete design aspects of power circuit elements and control circuit parameters. The compensation process is based on sensing line currents only, an approach different from conventional methods that require the harmonics and reactive volt-ampere requirement of the load. Various simulation results are presented to study the performance during steady-state and transient conditions to validate the design. A laboratory prototype has been developed to verify the simulation results. The control scheme is realized on a dedicated micro-controller-based system. PWM pattern generation is based on carrierless hysteresis-based current control to obtain the switching signals. Based on simulation and experimental results it can be concluded that the compensation process is simple and easy to implement. The spectral performance shows that the active filter brings the THD of the system well below 5%, the limit imposed by the IEEE-519 standard.
Related content
Access to resources
Recommend
