Is there any contradiction between the stress and energy failure criteria in micromechanical tests? Part III. Experimental observation of crack propagation in the microbond test

Author： Zhandarov Serge Pisanova Elena Mäder Edith

Publisher： Taylor & Francis Ltd

ISSN： 1568-5616

Source： Journal of Adhesion Science and Technology, Vol.19, Iss.8, 2005-08, pp. : 679-704

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

A direct observation of crack propagation in the microbond test was carried out for five different fiber/polymer matrix systems. This technique appeared to be a very effective tool for interface characterization. Experimental plots of the force required for further crack propagation as a function of debond length were analyzed using both energy-based and stress-based models of debonding. The fracture mechanics analysis was used to construct families of crack resistance or R-curves which showed the variation of energy release rate, G, with the debond length, and included the effect of interfacial friction in debonded regions. For the first time, analogs of the R-curves were created within the scope of the stress-based model to present the local shear stress near the crack tip, τ, as a function of crack length. In both models, the behavior of the interfacial parameter (G or τ) strongly depends on the assumed value of the interfacial frictional stress (τ_f). However, for each matrix/fiber system there exists such a τ_f value for which the investigated parameter is nearly constant over the whole region of stable crack propagation (70–90% of the embedded length). Moreover, these best-fit τ_f values for each specimen appeared to be practically the same for both energy-based and stress-based approaches. Thus, both interfacial toughness, G _ic, and local interfacial shear strength, τ_d, adequately characterize the strength of a fiber/matrix interface. Extrapolation of R-curves and their analogs to zero crack length allows measurement of the interfacial parameters with good accuracy.