Author： Mitchell Dana Gallagher Tom
Publisher： Society of American Foresters
ISSN： 0148-4419
Source： Southern Journal of Applied Forestry, Vol.31, Iss.4, 2007-11, pp. : 176-180
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.
Abstract
A time and motion study was conducted to determine the productivity and cost of an in-woods chipping operation when processing whole small-diameter trees for biomass. The study removed biomass from two overstocked stands and compared the cost of this treatment to existing alternatives. The treatment stands consisted of a 30-year-old longleaf pine stand and a 37-year-old loblolly pine stand. In the longleaf pine stand, 71% of the trees removed were less than 5 in. dbh. In the loblolly pine stand, approximately 81% of the stems removed were less than 5 in. dbh. The harvesting system consisted of conventional ground-based harvesting equipment and a three-knife chipper that processed the biomass into fuel chips. The average production time to fill a chip van was 24.61 minutes. The chip moisture content averaged 94.11% (dry basis). Using machine rates and federal labor wage rates, the in-woods cost of producing fuel chips was $9.18/green ton (gt). The cost of the biomass chipping operation ($15.18/gt), including transportation, compared favorably to existing alternative treatments of cut-and-pile or mulching.
Related content
Access to resources
Recommend
By Cutshall Jason B. Greene W. Dale Baker Shawn A.
Southern Journal of Applied Forestry, Vol. 37, Iss. 3, 2013-08 ,pp. :