Author: Jain M. Majumder S. B. Yuzyuk Yu. I. Katiyar R. S. Bhalla A. S. Miranda F. A. Keuls F. W. Van
Publisher: Taylor & Francis Ltd
ISSN: 0731-5171
Source: Ferroelectrics Letters Section, Vol.30, Iss.5-6, 2003-01, pp. : 99-107
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.
Abstract
(Ba1−xSrx)TiO3 (BST) is a suitable material for microelectronic device applications due to its high response of the dielectric permittivity to an applied electric field. However, the large dielectric constants found in this system limit its usefulness at microwave frequencies. In our recent studies sol-gel prepared Ba0.5Sr0.5TiO3:MgO heterostructured thin films have shown an increase in the figure of merit (tunability/loss) compared to pure Ba0.5Sr0.5TiO3 films, but the leakage characteristics of these films did not improve significantly. Moreover, due to the hygroscopic nature of MgO, the BST:MgO heterostructured films may suffer with longer period of time instability. In this paper we used the low loss and non-hygroscopic MgTiO3 for the fabrication of the Ba0.5Sr0.5TiO3:MgTiO3 (BST50:MT) heterostructured thin films by sol-gel technique and studied the effects of MgTiO3 layers on the structural, physical, dielectric properties, and leakage current behavior of the BST:MT films. The X-ray studies indicated that both MT and Ba0.5Sr0.5TiO3 are highly oriented and remain as two distinct individual entities in the composite films and a considerable reduction in the dielectric loss and leakage currents has been observed. High frequency phase shifter studies (at low voltage) suggest that these films are suitable for the tunable microwave device applications.
Related content
By Majumder S. B. Jain M. Martinez A. Katiyar R. S. Miranda F. A. Van Keuls F. W. Sahoo P. K. Kulkarni V. N.
Ferroelectrics, Vol. 267, Iss. 1, 2002-01 ,pp. :