Publisher： Academic Press
ISSN： 0021-8634
Source： Journal of Agricultural Engineering Research, Vol.78, Iss.3, 2001-03, pp. : 253-260
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.
Abstract
Meadow soil in China consists of extremely fine soil particles, is quite impermeable and has particular mechanical properties. This paper deals with the mechanical properties of the three horizons (Ap, A and Cg1) of meadow soil as an aid to understanding the draught requirement of a three-stage soil layer mixing plough for the improvement of the meadow soil. Pseudogley soil which is a typical heavy clay soil in Japan was also tested for comparison. Tensile strength, shear strength, soil–metal friction and soil–plastic friction were determined.The results show that the tensile strength of the meadow soil increased steeply at lower soil water contents. In the range of soil water content of more than 30% d.b., the tensile strength of the A horizon is the largest, followed by the Cg1 horizon, Ap horizon and pseudogley soil.The cohesive strengths of all soils showed a maximum at particular soil water contents. These soil water contents were nearly same as the plastic limits. Comparing the maximum value of the cohesion, the A horizon was the largest, followed by the Cg1, Ap horizon and the pseudogley soil.The adhesion to steel of all soils showed a maximum at particular soil water contents. These soil water contents were slightly larger than the plastic limits. Hence, the adhesion was highest under a wet soil condition. The maximum value for the adhesion of the A horizon was the largest, followed by the Ap, Cg1 and the pseudogley soil. Hence, all horizons of the meadow soil were much stickier than the pseudogley soil.The adhesion to polyethylene was smaller than that to steel. The soil water content, at which the adhesion showed a maximum, was the same as that for steel.
Access to resources
Recommend
