The design of a NURBS pre-interpolator for five-axis machining

By Li Wei   Liu Yadong   Yamazaki Kazuo   Fujisima Makoto   Mori Masahiko  

The International Journal of Advanced Manufacturing Technology, Vol. 36, Iss. 9-10, 2008-04 ,pp. : 927-935

Springer Publishing Company

Access to resources Recommend Favorite

A five-axis rough machining approach for a centrifugal impeller

By Young H.-T.   Chuang L.-C.   Gerschwiler K.   Kamps S.  

The International Journal of Advanced Manufacturing Technology, Vol. 23, Iss. 3-4, 2004-02 ,pp. : 233-239

Springer Publishing Company

Access to resources Recommend Favorite

On the B-spline interpolated tool trajectories for five-axis sculptured surface machining

By Tutunea-Fatan O. Remus   Feng Hsi-Yung  

International Journal of Manufacturing Research, Vol. 1, Iss. 2, 2006-11 ,pp. : 198-212

Inderscience Publishers

Access to resources Recommend Favorite

Investigation of tool orientation for milling blade of impeller in five-axis machining

By Chen Kuan-Hung  

The International Journal of Advanced Manufacturing Technology, Vol. 52, Iss. 1-4, 2011-01 ,pp. : 235-244

Springer Publishing Company

Access to resources Recommend Favorite

Automatic selection of cutter orientation for preventing the collision problem on a five-axis machining

By Hsueh Yao-Wen   Hsueh Ming-Hsien   Lien Hsin-Chung  

The International Journal of Advanced Manufacturing Technology, Vol. 32, Iss. 1-2, 2007-02 ,pp. : 66-77

Springer Publishing Company

Access to resources Recommend Favorite