Determining optimum EDM parameters in drilling a small hole by Taguchi method

Author： Yusoff Ahmad Razlan   Ghazalli Zakri   Hussain Hazami Che  

Publisher： Inderscience Publishers

ISSN： 1368-2148

Source： International Journal of Manufacturing Technology and Management, Vol.17, Iss.4, 2009-03, pp. : 345-352

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Influence of EDM process parameters in deep hole drilling of Inconel 718

By Kuppan P.   Rajadurai A.   Narayanan S.  

The International Journal of Advanced Manufacturing Technology, Vol. 38, Iss. 1-2, 2008-07 ,pp. : 74-84

Springer Publishing Company

Access to resources Recommend Favorite

Feasibility evaluation of EDM hole drilling method for residual stress measurement

By Lee H. T.   Hsu F. C.  

Materials Science and Technology, Vol. 19, Iss. 9, 2003-09 ,pp. : 1261-1265

Maney Publishing

Access to resources Recommend Favorite

Calibration of residual stress measurements obtained from EDM hole drilling method using physical material properties

By Lee H. T.   Liu C.  

Materials Science and Technology, Vol. 24, Iss. 12, 2008-12 ,pp. : 1462-1469

Maney Publishing

Access to resources Recommend Favorite

Optimization of Process Parameters in EDM Using Taguchi Method with Grey Relational Analysis and Topsis for Ceramic Composites

By  

International Journal of Engineering Research in Africa, Vol. 2016, Iss. 22, 2016-03 ,pp. : 83-93

Trans Tech Publications

Access to resources Recommend Favorite

Effect of flushing condition on deep hole micro-EDM drilling

By Meena Vijay Kumar   Azad Man Singh   Mitra Souren  

International Journal of Machining and Machinability of Materials, Vol. 12, Iss. 4, 2012-11 ,pp. : 308-320

Inderscience Publishers

Access to resources Recommend Favorite