Ni-based superalloy as a potential tool material for thixoforming of steels

ISSN： 1743-2812

Source： Ironmaking & Steelmaking, Vol.36, Iss.7, 2009-10, pp. : 555-560

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Effect of bulk die temperature on die cavity surface strains in thixoforming of steels

By Birol Y.

Ironmaking & Steelmaking, Vol. 36, Iss. 5, 2009-07 ,pp. : 397-400

Maney Publishing

Access to resources Recommend Favorite

Development of Ni–Al and Ni–Al–Fe intermetallic coatings on carbon tool steels

By Salehi M. Shamanian M. Ashrafizadeh F.

Surface Engineering, Vol. 13, Iss. 6, 1997-01 ,pp. : 505-508

Maney Publishing

Access to resources Recommend Favorite

Wear resistance of JIS SKD61 tool steels with Cr based coatings

Surface Engineering, Vol. 16, Iss. 3, 2000-06 ,pp. : 257-261

Maney Publishing

Access to resources Recommend Favorite

Response to thermal cycling of tool materials under steel thixoforming conditions

By Birol Y.

Ironmaking & Steelmaking, Vol. 37, Iss. 1, 2010-01 ,pp. : 41-46

Maney Publishing

Access to resources Recommend Favorite

Effect of wire electrical discharge machining parameters on surface roughness and volumetric material removal rate of tool steels

By Ramazi H. Nehzat N.

Ironmaking & Steelmaking, Vol. 36, Iss. 6, 2009-08 ,pp. : 451-455

Maney Publishing

Access to resources Recommend Favorite