Low temperature mechanical properties of quenched and tempered 0·4C–Ni–Cr–Mo steel after controlled rolling

ISSN： 1743-2847

Source： Materials Science and Technology, Vol.4, Iss.7, 1988-07, pp. : 613-620

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

The mechanical properties of a quenched and tempered 0·4C–Ni–Cr–Mo steel after controlled rolling (CRP steel) have been studied over the temperature range 77–293 K with the aim of developing a CRP steel for low temperature ultrahigh strength applications. The results obtained were compared with those of a conventional quenched and tempered 0·4C–Ni–Cr–Mo steel (CHT steel). The CRP process was found to improve greatly the strength, ductility, and fracture and impact toughness for tempers at and below 473 K, independent of test temperature, but there was some concomitant deterioration in the transverse properties. It is postulated that the fine subcell structure, introduced during the CRP, is mainly responsible for the improved mechanical properties. However, there is an abrupt reduction in fracture energy of fatigue precracked steels for tempers above 473 K, so above this temperature there is little difference in the properties of the CRP and CHT steels. This is attributed to fine carbide precipitation, which promotes shear localisation and dimple fracture. Despite this, it is demonstrated by the present work that the CRP steel is attractive for low temperature ultrahigh strength steel applications.MST/734