Modelling of poly(ethylene terephthalate) in injection stretch–blow moulding

Author： Menary G.H.   Armstrong C.G.   Crawford R.J.   McEvoy J.P.  

Publisher： Maney Publishing

ISSN： 1743-2898

Source： Plastics, Rubber and Composites, Vol.29, Iss.7, 2000-07, pp. : 360-370

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Induced crystallinity during stretch–blow moulding process and its influence on mechanical strength of poly(ethylene terephthalate) bottles

By Chevalier L.   Linhone C.   Regnier G.  

Plastics, Rubber and Composites, Vol. 28, Iss. 8, 1999-08 ,pp. : 393-400

Maney Publishing

Access to resources Recommend Favorite

Experimental study and numerical modelling of injection stretch blow moulding of angioplasty balloons

By Menary G. H.   Armstrong C. G.  

Plastics, Rubber and Composites, Vol. 35, Iss. 8, 2006-10 ,pp. : 348-354

Maney Publishing

Access to resources Recommend Favorite

Improvement of adhesion between poly(ethylene terephthalate) and polyethylene

By Durgun Hande   Bayram Goknur  

Journal of Adhesion Science and Technology, Vol. 19, Iss. 6, 2005-05 ,pp. : 407-425

Taylor & Francis Ltd

Access to resources Recommend Favorite

Mechanical response of amorphous and semicrystalline poly(ethylene terephthalate) and modelling in frame of quasi point defect theory

By Chabert E.   Ershad Langroudi A.   Gauthier C.   Perez J.  

Plastics, Rubber and Composites, Vol. 30, Iss. 2, 2001-02 ,pp. : 56-67

Maney Publishing

Access to resources Recommend Favorite

EFFECTS OF CURING TEMPERATURE ON POLY(ETHYLENE TEREPHTHALATE)

By Al-Raheil Ismail A.  

International Journal of Polymeric Materials, Vol. 51, Iss. 4, 2002-01 ,pp. : 315-323

Taylor & Francis Ltd

Access to resources Recommend Favorite