GTA welding of AISI 316L metal injection moulded components

ISSN： 1743-2901

Source： Powder Metallurgy, Vol.45, Iss.3, 2002-10, pp. : 201-203

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Experimental and numerical analysis on sintering behaviours of injection moulded components in 316L stainless steel powder

By Song J. Barriere T. Liu B. Gelin J. C. Michel G.

Powder Metallurgy, Vol. 53, Iss. 4, 2010-12 ,pp. : 295-304

Maney Publishing

Access to resources Recommend Favorite

Mechanical properties of metal injection moulded 316L stainless steel using both prealloy and master alloy techniques

By Heaney D. F. Mueller T. W. Davies P. A.

Powder Metallurgy, Vol. 47, Iss. 4, 2004-12 ,pp. : 367-373

Maney Publishing

Access to resources Recommend Favorite

Effect of TIG Welding and Manual Metal Arc Welding on Mechanical Properties of AISI 304 and 316L Austenitic Stainless Steel Sheets

Key Engineering Materials, Vol. 2017, Iss. 750, 2017-09 ,pp. : 26-33

Trans Tech Publications

Access to resources Recommend Favorite

Tensile Characteristics of Nitrogen Enhanced Powder Injection Moulded 316L Stainless Steel

By Rawers J. Croydon F. Krabbe R. Duttlinger N.

Powder Metallurgy, Vol. 39, Iss. 2, 1996-01 ,pp. : 125-129

Maney Publishing

Access to resources Recommend Favorite

Solvent debinding kinetics and sintered properties of injection moulded 316L stainless steel powder

By Eroglu S. Bakan H. I.

Powder Metallurgy, Vol. 48, Iss. 4, 2005-12 ,pp. : 329-332

Maney Publishing

Access to resources Recommend Favorite