New technological approach to fabrication of high density PM parts by cold pressing sintering

ISSN： 1743-2901

Source： Powder Metallurgy, Vol.47, Iss.3, 2004-09, pp. : 278-284

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Steel based infiltration to achieve full density, high performance PM parts

By Semel F.J. Narasimhan K.S.

Powder Metallurgy, Vol. 52, Iss. 2, 2009-06 ,pp. : 94-100

Maney Publishing

Access to resources Recommend Favorite

Influence of Density and Sintering Temperature on Fatigue Crack Growth and Fracture Toughness of FL4405 High Strength PM Steel

By Horn J. J. Stephens R. I. Prucher T.

Powder Metallurgy, Vol. 41, Iss. 3, 1998-01 ,pp. : 205-210

Maney Publishing

Access to resources Recommend Favorite

Influence of Density and Sintering Temperature on Monotonic, Cyclic, and Low Cycle Fatigue Behaviour of FL4405 High Strength PM Steel

By Sager E. A. Stephens R. I. Prucher T.

Powder Metallurgy, Vol. 41, Iss. 2, 1998-01 ,pp. : 103-108

Maney Publishing

Access to resources Recommend Favorite

PM structural parts move to higher density and performance

By Whittaker David

Powder Metallurgy, Vol. 50, Iss. 2, 2007-06 ,pp. : 99-105

Maney Publishing

Access to resources Recommend Favorite

Producing metal parts with selective laser sintering/hot isostatic pressing

By Das S.

JOM, Vol. 51, Iss. 4, 1999-04 ,pp. : 2-2

Springer Publishing Company

Access to resources Recommend Favorite