On development of press and sinter Al–Ni–Mg powder metallurgy alloys

Author： MacAskill I. A.   Donaldson I. W.   Bishop D. P.  

Publisher： Maney Publishing

ISSN： 1743-2901

Source： Powder Metallurgy, Vol.49, Iss.4, 2006-12, pp. : 314-322

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Evaluation of Press-and-Sinter Processing Parameters in Titanium Hydride Powder Metallurgy

By  

Key Engineering Materials, Vol. 2016, Iss. 704, 2016-09 ,pp. : 94-103

Trans Tech Publications

Access to resources Recommend Favorite

Effects of Fe and Ni additions on emerging Al-4·5Cu-1·5Mg powder metallurgy alloy

By Moreau E D   Donaldson I W   Hexemer R L   Paul Bishop* D P  

Canadian Metallurgical Quarterly, Vol. 52, Iss. 4, 2013-10 ,pp. : 380-390

Maney Publishing

Access to resources Recommend Favorite

Effects of Fe and Ni additions on an emerging Al‐4?Cu‐1?Mg powder metallurgy alloy: Part 1 – PM processing behaviour

By Moreau E D  

Canadian Metallurgical Quarterly, Vol. 52, Iss. 1, 2013-01 ,pp. : 51-59

Maney Publishing

Access to resources Recommend Favorite

Powder metallurgy processing of Al-Cu-Mg alloy with low Cu/Mg ratio

By Cooke R W   Hexemer R L   Donaldson I W   Bishop D P  

Powder Metallurgy, Vol. 55, Iss. 1, 2012-02 ,pp. : 29-35

Maney Publishing

Access to resources Recommend Favorite

Tensile properties of sinter hardened powder metallurgy components machined in their green state

By Robert-Perron E.   Blais C.   Pelletier S.  

Powder Metallurgy, Vol. 52, Iss. 1, 2009-03 ,pp. : 80-83

Maney Publishing

Access to resources Recommend Favorite