Effect of sintering parameters on mechanical properties of injection moulded Ti–6Al–4V alloys

Author： Ergül E.   Özkan Gülsoy H.   Günay V.  

Publisher： Maney Publishing

ISSN： 1743-2901

Source： Powder Metallurgy, Vol.52, Iss.1, 2009-03, pp. : 65-71

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Sintering parameters and mechanical properties of injection moulded aluminium powder

By Acar L   Gülsoy H Ö  

Powder Metallurgy, Vol. 54, Iss. 3, 2011-07 ,pp. : 427-431

Maney Publishing

Access to resources Recommend Favorite

Powder Metallurgy Ti-6Al-4V Alloy with Wrought-Like Microstructure and Mechanical Properties by Hydrogen Sintering

By  

Key Engineering Materials, Vol. 2016, Iss. 704, 2016-09 ,pp. : 3-14

Trans Tech Publications

Access to resources Recommend Favorite

The GTAW of Ti-6Al-4V castings and its effect on microstructural and mechanical properties

By Ault James   Pillers James   Veeck Stewart  

JOM, Vol. 57, Iss. 11, 2005-11 ,pp. : 62-65

Springer Publishing Company

Access to resources Recommend Favorite

An investigation of the effect of fatigue deformation on the residual mechanical properties of Ti-6Al-4V ELI

By Akahori Toshikazu   Niinomi Mitsuo   Fukunaga Kei-Ichi  

Metallurgical and Materials Transactions A, Vol. 31, Iss. 8, 2000-08 ,pp. : 1937-1948

Springer Publishing Company

Access to resources Recommend Favorite

Microstructure and Mechanical Properties of Ti-6Al-4V Manufactured by SLM

By  

Key Engineering Materials, Vol. 2015, Iss. 651, 2015-08 ,pp. : 677-682

Trans Tech Publications

Access to resources Recommend Favorite