Effect of cutting parameters on cutting force and surface roughness in milling alumina reinforced Al-6Zn-2Mg-2Cu composites

Author： Übeyli M   Acır A   Keleş Ö   Akçay C E  

Publisher： Maney Publishing

ISSN： 1743-2901

Source： Powder Metallurgy, Vol.54, Iss.2, 2011-04, pp. : 172-176

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

The Effect of the Cutting Parameters on the Machined Surface Roughness

By  

Solid State Phenomena, Vol. 2017, Iss. 260, 2017-08 ,pp. : 219-226

Trans Tech Publications

Access to resources Recommend Favorite

Investigation of the effect of cutting speed on the Surface Roughness parameters in CNC End Milling using Artificial Neural Network

By  

IOP Conference Series: Materials Science and Engineering, Vol. 53, Iss. 1, 2013-12 ,pp. : 716-727

IOP Publishing

Access to resources Recommend Favorite

Analyzing the effect of cutting parameters on surface roughness and tool wear when machining nickel based hastelloy – 276

By  

IOP Conference Series: Materials Science and Engineering, Vol. 17, Iss. 1, 2011-02 ,pp. : 377-386

IOP Publishing

Access to resources Recommend Favorite

Research on Cutting Force of Corner Milling of Inclined Plane

By  

Key Engineering Materials, Vol. 2016, Iss. 693, 2016-06 ,pp. : 856-862

Trans Tech Publications

Access to resources Recommend Favorite

Modelling and Analysis of Relationship between Cutting Parameters Surface Roughness and Cutting Forces Using Response Surface Methodology when Hard Turning with Coated Ceramic Inserts

By  

Key Engineering Materials, Vol. 2016, Iss. 686, 2016-03 ,pp. : 19-26

Trans Tech Publications

Access to resources Recommend Favorite