Metallurgical analysis of Al/Cu friction stir spot welding

ISSN： 1743-2936

Source： Science and Technology of Welding & Joining, Vol.15, Iss.7, 2010-10, pp. : 597-604

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Tensile Strength and Metallurgical Analysis in Anodized Al/Cu Joint Using Friction Stir Welding

Key Engineering Materials, Vol. 2015, Iss. 656, 2015-08 ,pp. : 490-495

Trans Tech Publications

Access to resources Recommend Favorite

Enhancing metallurgical and mechanical properties of friction stir lap welding of Al‐Cu using intermediate layer

By Akbari M

Science and Technology of Welding & Joining, Vol. 18, Iss. 6, 2013-08 ,pp. : 518-524

Maney Publishing

Access to resources Recommend Favorite

Friction Stir Welding of Dissimilar Al-Cu Lap Joints with Copper on Top

Key Engineering Materials, Vol. 2016, Iss. 724, 2017-02 ,pp. : 71-76

Trans Tech Publications

Access to resources Recommend Favorite

Microstructural analysis of stir zone of Al alloy produced by friction stir spot welding

By Fujimoto M. Koga S. Abe N. Sato Y. S. Kokawa H.

Science and Technology of Welding & Joining, Vol. 13, Iss. 7, 2008-10 ,pp. : 663-670

Maney Publishing

Access to resources Recommend Favorite

Novel spot friction stir welding of 6061 and 5052 Al alloys

By Sun Y F Fujii H Takaki N Okitsu Y

Science and Technology of Welding & Joining, Vol. 16, Iss. 7, 2011-10 ,pp. : 605-612

Maney Publishing

Access to resources Recommend Favorite