Effect of shoulder cavity and welding parameters on friction stir welding of thin copper sheets

Author： Leal R M Sakharova N Vilaça P Rodrigues D M Loureiro A

ISSN： 1743-2936

Source： Science and Technology of Welding & Joining, Vol.16, Iss.2, 2011-02, pp. : 146-152

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

The aim of this investigation was to study the influence of shoulder cavity and welding parameters on torque, defect formation, microstructure and mechanical properties of friction stir welds in very thin sheets of deoxidised copper. Three types of tools were used: a flat shoulder tool and two tools with conical shoulder cavities of 3 and 6° respectively. The welding parameters analysed were tool rotation and traverse speeds. It was observed that the torque, the microstructure and hardness and the formation of defects in the welds are influenced mainly by tool rotation speed and, to a lesser extent, by the traverse speed and shoulder cavity. The tensile properties of welds carried out at high rotation speeds are little affected by the shoulder cavity.