Reducing distortion due to heat treatment by modifying part geometry

Author： Andersch C.   Schwarzer J.   Hoffmann F.   Zoch H.-W.  

Publisher： Maney Publishing

ISSN： 1749-5156

Source： International Heat Treatment & Surface Engineering, Vol.3, Iss.1-2, 2009-06, pp. : 60-64

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

On reducing the post-heat-treatment time of the weldment

By Jahanian S.   Kunde R.   Kuppa P.  

Journal of Materials Engineering and Performance, Vol. 9, Iss. 1, 2000-02 ,pp. : 72-80

Springer Publishing Company

Access to resources Recommend Favorite

Effect of heat treatment and reducing agent on remanence and coercivity of reduced hematite ores

By Toomver T.T.   Ross H.U.  

Canadian Metallurgical Quarterly, Vol. 10, Iss. 1, 1971-01 ,pp. : 65-66

Maney Publishing

Access to resources Recommend Favorite

Failure of a Rear Axle Shaft of an Automobile Due to Improper Heat Treatment

By Tawancy H.  

Journal of Failure Analysis & Prevention, Vol. 13, Iss. 3, 2013-06 ,pp. : 353-358

Springer Publishing Company

Access to resources Recommend Favorite

Modifying residual stress levels in rail flash-butt welds using localised rapid post-weld heat treatment and accelerated cooling

By Tawfik D.   Mutton P. J.   Chiu W. K.  

International Heat Treatment & Surface Engineering, Vol. 2, Iss. 3-4, 2008-12 ,pp. : 126-130

Maney Publishing

Access to resources Recommend Favorite

Estimating equilibration times and heating/cooling rates in heat treatment of workpieces with arbitrary geometry

By Gao M.   Reid C.   Jahedi M.   Li Y.  

Journal of Materials Engineering and Performance, Vol. 9, Iss. 1, 2000-02 ,pp. : 62-71

Springer Publishing Company

Access to resources Recommend Favorite