Early history of the development and characterization of a 50 mm diameter, gas-operated piston gauge as a primary pressure standard

Author： Delajoud P.   Girard M.   Ehrlich C. D.  

Publisher： IOP Publishing

ISSN： 0026-1394

Source： Metrologia, Vol.36, Iss.6, 1999-12, pp. : 521-524

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Piston-cylinder assemblies of 5 cm2 cross-sectional area used in an oil-operated primary pressure balance standard for the 10 MPa range

By Jager J.   Sabuga W.   Wassmann D.  

Metrologia, Vol. 36, Iss. 6, 1999-12 ,pp. : 541-544

IOP Publishing

Access to resources Recommend Favorite

CCM key comparison in the pressure range 50 kPa to 1000 kPa (gas medium, gauge mode). Phase A2: Pressure measurements

By Legras J. C.   Sabuga W.   Molinar G. F.   Schmidt J. W.  

Metrologia, Vol. 36, Iss. 6, 1999-12 ,pp. : 663-668

IOP Publishing

Access to resources Recommend Favorite

A primary standard for the volume flow rate of natural gas under high pressure based on laser Doppler velocimetry

By Mickan B   Strunck V  

Metrologia, Vol. 51, Iss. 5, 2014-10 ,pp. : 459-475

IOP Publishing

Access to resources Recommend Favorite

Dynamic pressure corrections in a clearance-sealed piston prover for gas flow measurements

By Kutin Jože   Bobovnik Gregor   Bajsić Ivan  

Metrologia, Vol. 50, Iss. 1, 2013-02 ,pp. : 66-72

IOP Publishing

Access to resources Recommend Favorite

A primary pressure standard at 100 kPa

By Schmidt J. W.   Cen Yueqin   Driver R. G.   Bowers W. J.   Houck J. C.   Tison S. A.  

Metrologia, Vol. 36, Iss. 6, 1999-12 ,pp. : 525-529

IOP Publishing

Access to resources Recommend Favorite