Annealing effect on structural, optical and electrical properties of pure and Mg doped tin oxide thin films

Author： Ali Syed Muhammad Jan Hussain Syed Ali Syed Rehman Naeem Aziz Muhammad

ISSN： 0957-4522

Source： Journal of Materials Science: Materials in Electronics, Vol.24, Iss.12, 2013-12, pp. : 4925-4931

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

This study describes the effect of annealing at different temperatures (400–600 °C) on structural, optical and electrical behaviors of pure and Mg doped tin oxide thin films grown on the glass substrate by electron beam evaporation technique. The transformation of tetragonal to orthorhombic form due to annealing, introduced a change in the optical and electrical properties of pure and Mg doped tin oxide thin films. X-ray diffraction studies or analysis revealed the phase transformation and change in the crystalline size with increase in the annealing temperature. The morphology and roughness of the thin films were studied by Atomic force microscopy. Optical band gap increased with annealing temperature confirms the improvements of crystallinity. The quality of thin films transparency was investigated by UV/Vis-spectroscopy. Photoluminescence of pure and Mg doped tin oxide thin films shows two extra peaks one at 486 nm and other at 538 nm is due to the crystal defect created as a result of annealing temperature. These peaks became stronger and shifted to longer wavelength with increasing the annealing temperature. The complex plot (Nyquist plot) showed the data point laying on two semicircles and the resistance of grains and grain boundaries increases with the increase in annealing temperature for both pure and Mg doped tin oxide thin films.