The Effects of Environmental Water and Oxygen on the Temperature-Dependent Friction of Sputtered Molybdenum Disulfide

ISSN： 1023-8883

Source： Tribology Letters, Vol.52, Iss.3, 2013-12, pp. : 485-493

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Molybdenum disulfide (MoS₂) is well known for exceptional friction and wear properties in inert and high vacuum environments. However, these tribological properties degrade in humid and high temperature environments for reasons that are not fully understood. A prevailing hypothesis suggests that moisture and thermal energy facilitate oxidation, which increases the shear strength of the sliding interface. The purpose of this study is to elucidate the contributions of water, oxygen, and temperature to the tribological degradation of MoS₂. Generally speaking, we found a minimum friction coefficient that occurred at a temperature we defined as the transition temperature. This transition temperature ranged from 100 to 250 °C and was a strong function of the MoS₂ preparation and thermal sliding history. Below the transition temperature, friction increased with increased water, but was insensitive to oxygen. Above the transition, friction increased with increased oxygen, but decreased to a limited extent with increased water. These results are generally consistent with prior results, but clarify some inconsistencies in the literature discussions. Contrary to the prevailing hypothesis, the results suggest that water does not promote oxidation near room temperature, but directly interferes with lamellar shear through physical bonding. Increased temperatures drive off water and thereby reduce friction up to the transition temperature. The results suggest that oxidation causes increased friction with increased temperature above the transition temperature. The data also suggest that water helps mitigate high temperature oxidation by displacing the environmental oxygen or by preferentially adsorbing to the surface.