Sintering of injection-moulded WC–7 wt% Ni in a hydrogen atmosphere

ISSN： 0022-2461

Source： Journal of Materials Science, Vol.32, Iss.12, 1997-12, pp. : 3207-3212

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Sintering of a boron-doped injection moulded 17-4PH stanless steel

By Gülsoy H. Salman S. Özbek S. Findik F.

Journal of Materials Science, Vol. 40, Iss. 15, 2005-08 ,pp. : 4101-4104

Springer Publishing Company

Access to resources Recommend Favorite

Processing of Injection Moulded of Synthesized HAp by Single Step Wick-Debinding and Sintering

Advanced Materials Research, Vol. 2015, Iss. 1113, 2015-08 ,pp. : 105-109

Trans Tech Publications

Access to resources Recommend Favorite

Residual Stresses in Short-Fibre Reinforced Injection-Moulded Thermoplastic Parts

By Mlekusch B.A.

Mechanics of Time-Dependent Materials, Vol. 2, Iss. 2, 1998-01 ,pp. : 129-169

Springer Publishing Company

Access to resources Recommend Favorite

Rapid sintering of ultra-fine WC-10 wt% Co by high-frequency induction heating

By Kim H. Shon I. Munir Z.

Journal of Materials Science, Vol. 40, Iss. 11, 2005-06 ,pp. : 2849-2854

Springer Publishing Company

Access to resources Recommend Favorite

Effect of FeB additions on sintering characteristics of injection moulded 17-4PH stainless steel powder

By Gülsoy H. Ö. Salman S. Özbek S.

Journal of Materials Science, Vol. 39, Iss. 15, 2004-08 ,pp. : 4835-4840

Springer Publishing Company

Access to resources Recommend Favorite