Temperature and weldline effects on tensile properties of injection moulded short glass fibre PC/ABS polymer composite

ISSN： 0022-2461

Source： Journal of Materials Science, Vol.42, Iss.8, 2007-04, pp. : 2652-2661

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Mechanical properties of injection-moulded styrene maleic anhydride (SMA): Part I: Influence of weldline and reprocessing

By CHRYSOSTOMOU A HASHEMI S

Journal of Materials Science, Vol. 33, Iss. 5, 1998-03 ,pp. : 1165-1175

Springer Publishing Company

Access to resources Recommend Favorite

Influence of short glass fibres and weldlines on the mechanical properties of injection-moulded acrylonitrile–styrene–acrylate copolymer

By Nabi Z. U Hashemi S

Journal of Materials Science, Vol. 33, Iss. 12, 1998-06 ,pp. : 2985-3000

Springer Publishing Company

Access to resources Recommend Favorite

Mechanical properties of injection moulded styrene maleic anhydride (SMA) Part II Influence of short glass fibres and weldlines

By CHRYSOSTOMOU A. HASHEMI S.

Journal of Materials Science, Vol. 33, Iss. 18, 1998-09 ,pp. : 4491-4501

Springer Publishing Company

Access to resources Recommend Favorite

Residual Stresses in Short-Fibre Reinforced Injection-Moulded Thermoplastic Parts

By Mlekusch B.A.

Mechanics of Time-Dependent Materials, Vol. 2, Iss. 2, 1998-01 ,pp. : 129-169

Springer Publishing Company

Access to resources Recommend Favorite

Effects of interphase and impact strain rates on tensile off-axis behaviour of unidirectional glass fibre composite: experimental results

By Agbossou A. Cohen I. Muller D.

Engineering Fracture Mechanics, Vol. 52, Iss. 5, 1995-11 ,pp. : 923-935

Elsevier

Access to resources Recommend Favorite