Allowing for Reserve Frictional Forces in the Design of Roll Fittings

Author： Fastykovskii A.R.   Peretyat'ko V.N.  

Publisher： Springer Publishing Company

ISSN： 0026-0894

Source： Metallurgist, Vol.45, Iss.11-12, 2001-11, pp. : 495-499

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Determination of Frictional Forces during Wire Rod Drawing Process by Reverse Method

By  

Solid State Phenomena, Vol. 2017, Iss. 265, 2017-10 ,pp. : 1152-1156

Trans Tech Publications

Access to resources Recommend Favorite

Cold Roll Forming Process and Die Design for Double-Gutter Frame of Drawer Slider

By  

Key Engineering Materials, Vol. 2014, Iss. 626, 2015-01 ,pp. : 205-210

Trans Tech Publications

Access to resources Recommend Favorite

Modification of Roll Pass Design of Low Pearlite, Fine-Grained Sheet Steel Using Numerical Modeling and Processing Maps

By El-Bitar Taher  

Canadian Metallurgical Quarterly, Vol. 39, Iss. 3, 2000-01 ,pp. : 319-324

Maney Publishing

Access to resources Recommend Favorite

Analysis of Efficiency of Roll Pass Design Options for Roughing Stands of Section Rolling Mill

By  

Solid State Phenomena, Vol. 2017, Iss. 265, 2017-10 ,pp. : 1136-1141

Trans Tech Publications

Access to resources Recommend Favorite

Theoretical Investigation of the Inclined Sidewall Design on Magnetohydrodynamic (MHD) Forces in an Aluminum Electrolytic Cell

By Das Subrat  

Metallurgical and Materials Transactions B, Vol. 42, Iss. 1, 2011-02 ,pp. : 243-253

Springer Publishing Company

Access to resources Recommend Favorite