A general approach for predicting the drawing fracture load and limit drawing ratio of an axisymmetric drawing process

Author： Deng Zhi   Lovell M.   Bleck Wolfgang   Papamantellos Kostas  

Publisher： Springer Publishing Company

ISSN： 1543-1940

Source： Metallurgical and Materials Transactions A, Vol.30, Iss.10, 1999-10, pp. : 2619-2627

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

New Approach for Wrinkle Prediction in Deep Drawing Process

By  

Key Engineering Materials, Vol. 2015, Iss. 639, 2015-04 ,pp. : 459-466

Trans Tech Publications

Access to resources Recommend Favorite

Estimating surface hardening profile of blank for obtaining high drawing ratio in deep drawing process using FE analysis

By  

IOP Conference Series: Materials Science and Engineering, Vol. 103, Iss. 1, 2015-12 ,pp. : 338-343

IOP Publishing

Access to resources Recommend Favorite

Curvature Based Forming Limit Prediction of High-Strength Steel Components with Superimposed Stretching and Bending in the Deep Drawing Process

By  

Key Engineering Materials, Vol. 2015, Iss. 651, 2015-08 ,pp. : 181-186

Trans Tech Publications

Access to resources Recommend Favorite

Influence of Single and Summary Deformation for the Change of Limit Stress in the Drawing Process Based on the Pelczynski Diagram

By  

Solid State Phenomena, Vol. 2016, Iss. 246, 2016-03 ,pp. : 183-188

Trans Tech Publications

Access to resources Recommend Favorite

Research of the Laboratory Wire Drawing Process of Zinc

By  

Key Engineering Materials, Vol. 2016, Iss. 682, 2016-03 ,pp. : 367-371

Trans Tech Publications

Access to resources Recommend Favorite