The Effect of Matrix Microstructure on the Tensile and Fatigue Behavior of SiC Particle–Reinforced 2080 Al Matrix Composites

Author： Chawla N. Habel U. Shen Y.-L. Andres C. Jones J.W. Allison J.E.

Publisher： Springer Publishing Company

ISSN： 1543-1940

Source： Metallurgical and Materials Transactions A, Vol.31, Iss.2, 2000-02, pp. : 531-540

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

The effect of matrix microstructure on the stress-controlled fatigue behavior of a 2080 Al alloy reinforced with 30 pct SiC particles was investigated. A thermomechanical heat treatment (T8) produced a fine and homogeneous distribution of S′ precipitates, while a thermal heat treatment (T6) resulted in coarser and inhomogeneously distributed S′ precipitates. The cyclic and monotonic strength, as well as the cyclic stress-strain response, were found to be significantly affected by the microstructure of the matrix. Because of the finer and more-closely spaced precipitates, the composite given the T8 treatment exhibited higher yield strengths than the T6 materials. Despite its lower yield strength, the T6 matrix composite exhibited higher fatigue resistance than the T8 matrix composite. The cyclic deformation behavior of the composites is compared to monotonic deformation behavior and is explained in terms of microstructural instabilities that cause cyclic hardening or softening. The effect of precipitate spacing and size has a significant effect on fatigue behavior and is discussed. The interactive role of matrix strength and SiC reinforcement on stress within "rogue" inclusions was quantified using a finite-element analysis (FEA) unit-cell model.