A comparison of cylindrical and row trenched cooling holes with alignment angle of 0 degree near the combustor endwall

Publisher： IOP Publishing

ISSN： 1757-899X

Source： IOP Conference Series: Materials Science and Engineering, Vol.50, Iss.1, 2013-12, pp. : 50-55

Access to resources Favorite

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

The Use of Cooling Holes to Decrease the Amount of Thermal Damage on a Plastic Gear Tooth

By Düzcükoğlu Hayrettin   Yakut Rifat   Uysal Eyyub  

Journal of Failure Analysis & Prevention, Vol. 10, Iss. 6, 2010-12 ,pp. : 545-555

Springer Publishing Company

Access to resources Recommend Favorite

Effect of Entrainment Ratio and Subcooling Degree on Dual System of Cooling-Thermal Energy Conversion Applying Ejector

By  

Defect and Diffusion Forum, Vol. 2017, Iss. 379, 2017-12 ,pp. : 140-148

Trans Tech Publications

Access to resources Recommend Favorite

Combined effect of bismuth content and cooling rate on microstructure and mechanical properties of Al‐8?Si‐0?Mg‐0?Fe alloy

By Farahany S  

Canadian Metallurgical Quarterly, Vol. 52, Iss. 2, 2013-04 ,pp. : 208-216

Maney Publishing

Access to resources Recommend Favorite

Combined effect of cooling slope angle and mould vibration on semisolid microstructures of wrought aluminium alloy 7075

By Movahedi M.   Taheri A. Karimi   Niamanesh H.  

International Journal of Cast Metals Research, Vol. 20, Iss. 4, 2007-08 ,pp. : 221-227

Maney Publishing

Access to resources Recommend Favorite

The Effects of Finish Rolling Temperature and Cooling Interrupt Conditions on Precipitation in Microalloyed Steels Using Small Angle Neutron Scattering

By Wiskel J.B.   Ivey D.G.   Henein H.  

Metallurgical and Materials Transactions B, Vol. 39, Iss. 1, 2008-02 ,pp. : 116-124

Springer Publishing Company

Access to resources Recommend Favorite