Electrical discharge machining (EDM) of Inconel 718 by using copper electrode at higher peak current and pulse duration

Publisher： IOP Publishing

ISSN： 1757-899X

Source： IOP Conference Series: Materials Science and Engineering, Vol.50, Iss.1, 2013-12, pp. : 471-477

Access to resources Favorite

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Evaluating the electrical discharge machining (EDM) parameters with using carbon nanotubes

By  

IOP Conference Series: Materials Science and Engineering, Vol. 40, Iss. 1, 2012-09 ,pp. : 171-176

IOP Publishing

Access to resources Recommend Favorite

Experimental Investigations during Dry EDM of Inconel - 718

By  

IOP Conference Series: Materials Science and Engineering, Vol. 114, Iss. 1, 2016-02 ,pp. : 335-342

IOP Publishing

Access to resources Recommend Favorite

Micro Electrical Discharge Machining of Tungsten Carbide with Ultra-Short Pulse

By  

Key Engineering Materials, Vol. 2015, Iss. 651, 2015-08 ,pp. : 759-764

Trans Tech Publications

Access to resources Recommend Favorite

Control of Laves phase in Inconel 718 GTA welds with current pulsing

By Janaki Ram G.D.   Venugopal Reddy A.   Prasad Rao K.   Madhusudhan Reddy G.  

Science and Technology of Welding & Joining, Vol. 9, Iss. 5, 2004-10 ,pp. : 390-398

Maney Publishing

Access to resources Recommend Favorite

Study of Inconel 718 weldability using MIG CMT process

By Benoit A   Jobez S   Paillard P   Klosek V   Baudin T  

Science and Technology of Welding & Joining, Vol. 16, Iss. 6, 2011-08 ,pp. : 477-482

Maney Publishing

Access to resources Recommend Favorite