Mold-filling characteristics of AZ91 magnesium alloy in the low-pressure expendable pattern casting process

By Wu H.   Fan Z.   Huang N.   Dong X.   Tian X.  

Journal of Materials Engineering and Performance, Vol. 14, Iss. 1, 2005-02 ,pp. : 132-135

Springer Publishing Company

Access to resources Recommend Favorite

Casting/mold thermal contact heat transfer during solidification of Al-Cu-Si alloy (LM 21) plates in thick and thin molds

By Prabhu K.   Chowdary Bheemappa   Venkataraman N.  

Journal of Materials Engineering and Performance, Vol. 14, Iss. 5, 2005-10 ,pp. : 604-609

Springer Publishing Company

Access to resources Recommend Favorite

Determination of interfacial heat-transfer boundary conditions in an aluminum low-pressure permanent mold test casting

By Hines Joy  

Metallurgical and Materials Transactions B, Vol. 35, Iss. 2, 2004-04 ,pp. : 299-311

Springer Publishing Company

Access to resources Recommend Favorite

Influence of process parameters on filling ability of A356 aluminium alloy in expendable pattern shell casting with vacuum and low pressure

By Jiang W M   Fan Z T   Liu D J   Liao D F   Zhao Z   Dong X P   Wu H B  

International Journal of Cast Metals Research, Vol. 25, Iss. 1, 2012-01 ,pp. : 47-52

Maney Publishing

Access to resources Recommend Favorite

Four-phase fully-coupled mold-filling and solidification simulation for gas porosity prediction in aluminum sand casting

By  

IOP Conference Series: Materials Science and Engineering, Vol. 33, Iss. 1, 2012-07 ,pp. : 620-629

IOP Publishing

Access to resources Recommend Favorite