A five-axis rough machining approach for a centrifugal impeller

Author： Young H.-T.   Chuang L.-C.   Gerschwiler K.   Kamps S.  

Publisher： Springer Publishing Company

ISSN： 0268-3768

Source： The International Journal of Advanced Manufacturing Technology, Vol.23, Iss.3-4, 2004-02, pp. : 233-239

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Related content

Investigation of tool orientation for milling blade of impeller in five-axis machining

By Chen Kuan-Hung  

The International Journal of Advanced Manufacturing Technology, Vol. 52, Iss. 1-4, 2011-01 ,pp. : 235-244

Springer Publishing Company

Access to resources Recommend Favorite

Five-axis machining: technologies and challenges

By Rauch Matthieu   Xu Xun  

International Journal of Manufacturing Research, Vol. 5, Iss. 3, 2010-06 ,pp. : 327-352

Inderscience Publishers

Access to resources Recommend Favorite

The design of a NURBS pre-interpolator for five-axis machining

By Li Wei   Liu Yadong   Yamazaki Kazuo   Fujisima Makoto   Mori Masahiko  

The International Journal of Advanced Manufacturing Technology, Vol. 36, Iss. 9-10, 2008-04 ,pp. : 927-935

Springer Publishing Company

Access to resources Recommend Favorite

On the B-spline interpolated tool trajectories for five-axis sculptured surface machining

By Tutunea-Fatan O. Remus   Feng Hsi-Yung  

International Journal of Manufacturing Research, Vol. 1, Iss. 2, 2006-11 ,pp. : 198-212

Inderscience Publishers

Access to resources Recommend Favorite

Automatic selection of cutter orientation for preventing the collision problem on a five-axis machining

By Hsueh Yao-Wen   Hsueh Ming-Hsien   Lien Hsin-Chung  

The International Journal of Advanced Manufacturing Technology, Vol. 32, Iss. 1-2, 2007-02 ,pp. : 66-77

Springer Publishing Company

Access to resources Recommend Favorite