Research on the localisation of the workpieces with large sculptured surfaces in NC machining

Author： Sijie Y.   Yunfei Z.   Fangyu P.   Xide L.  

Publisher： Springer Publishing Company

ISSN： 0268-3768

Source： The International Journal of Advanced Manufacturing Technology, Vol.23, Iss.5-6, 2004-03, pp. : 429-435

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Related content

Three-half and half-axis patch-by-patch NC machining of sculptured surfaces

By Roman Armando   Bedi S.   Ismail F.  

The International Journal of Advanced Manufacturing Technology, Vol. 29, Iss. 5, 2006-06 ,pp. : 524-531

Springer Publishing Company

Access to resources Recommend Favorite

Machining of complex sculptured surfaces with feed rate scheduling

By Kaymakci Mustafa   Lazoglu Ismail   Murtezaoglu Yavuz  

International Journal of Manufacturing Research, Vol. 1, Iss. 2, 2006-11 ,pp. : 157-175

Inderscience Publishers

Access to resources Recommend Favorite

Multiple-axis sculptured surface machining

By Chiou John C.J.   Lee Yuan-Shin  

International Journal of Manufacturing Research, Vol. 1, Iss. 2, 2006-11 ,pp. : 213-247

Inderscience Publishers

Access to resources Recommend Favorite

An investigation for improvement of sculptured surface machining through a feedrate modification algorithm

By Chowdary Boppana V.   Gittens Anton  

International Journal of Manufacturing Research, Vol. 8, Iss. 2, 2013-04 ,pp. : 207-226

Inderscience Publishers

Access to resources Recommend Favorite

On the B-spline interpolated tool trajectories for five-axis sculptured surface machining

By Tutunea-Fatan O. Remus   Feng Hsi-Yung  

International Journal of Manufacturing Research, Vol. 1, Iss. 2, 2006-11 ,pp. : 198-212

Inderscience Publishers

Access to resources Recommend Favorite