Design and FEM analysis of the milled groove insert method for cooling of plastic injection moulds

ISSN： 0268-3768

Source： The International Journal of Advanced Manufacturing Technology, Vol.24, Iss.9-10, 2004-11, pp. : 715-726

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Related content

An object-oriented design tool for associative cooling channels in plastic-injection moulds

By Ma Y.-S. Tong T.

The International Journal of Advanced Manufacturing Technology, Vol. 23, Iss. 1-2, 2004-01 ,pp. : 79-86

Springer Publishing Company

Access to resources Recommend Favorite

FEA simulation of conformal cooling within injection moulds

By Gloinn Tomas O Hayes Conor Hanniffy P. Vaugh Keith

International Journal of Manufacturing Research, Vol. 2, Iss. 2, 2007-07 ,pp. : 162-170

Inderscience Publishers

Access to resources Recommend Favorite

A scaffolding architecture for conformal cooling design in rapid plastic injection moulding

By Au K. Yu K.

The International Journal of Advanced Manufacturing Technology, Vol. 34, Iss. 5-6, 2007-09 ,pp. : 496-515

Springer Publishing Company

Access to resources Recommend Favorite

A scaffolding architecture for conformal cooling design in rapid plastic injection moulding

By Au K. Yu K.

The International Journal of Advanced Manufacturing Technology, Vol. 34, Iss. 5-6, 2007-09 ,pp. : 516-516

Springer Publishing Company

Access to resources Recommend Favorite

Inverse method for the cooling system design in injection moulding – application to a ‘T-shaped’ piece

By Agazzi A. Sobotka V. LeGoff R. Jarny Y.

Inverse Problems in Science and Engineering, Vol. 22, Iss. 5, 2014-07 ,pp. : 707-726

Taylor & Francis Ltd

Access to resources Recommend Favorite