Mechanical and Tribological Characterization of Al-Mg₂Si Composites After Yttrium Addition and Heat Treatment

Author： Jafari Nodooshan H. Liu Wencai Wu Guohua Bahrami A. Pech-Canul M. Emamy M.

ISSN： 1059-9495

Source： Journal of Materials Engineering and Performance, Vol.23, Iss.4, 2014-04, pp. : 1146-1156

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Related content

Development of a Cast Al-Mg 2 Si-Si In Situ Composite: Microstructure, Heat Treatment, and Mechanical Properties

By Georgatis E.

Journal of Materials Engineering and Performance, Vol. 22, Iss. 3, 2013-03 ,pp. : 729-741

Springer Publishing Company

Access to resources Recommend Favorite

Influence of Cr and Mn Addition and Heat Treatment on the Corrosion Behaviour of an AlSi3Mg Alloy

Key Engineering Materials, Vol. 2017, Iss. 754, 2017-10 ,pp. : 11-14

Trans Tech Publications

Access to resources Recommend Favorite

Aging Effects on Heat Treatment Response and Mechanical Properties of Al-(1 to 13 pct)Si-Mg Cast Alloys

By Lados Diana

Metallurgical and Materials Transactions B, Vol. 42, Iss. 1, 2011-02 ,pp. : 181-188

Springer Publishing Company

Access to resources Recommend Favorite

Influence of silicon content and heat treatment parameters on mechanical properties of cast Al–Si–Mg alloys

By Dwivedi D. K. Sharma R. Kumar A.

International Journal of Cast Metals Research, Vol. 19, Iss. 5, 2006-10 ,pp. : 275-282

Maney Publishing

Access to resources Recommend Favorite

Effect of Si additions and heat treatment on the mechanical behaviour of an Al–5Mg casting alloy

By Johannesson B. Cáceres C.H.

International Journal of Cast Metals Research, Vol. 17, Iss. 2, 2004-02 ,pp. : 94-98

Maney Publishing

Access to resources Recommend Favorite