Effect of Ultrasonic Vibrations on Chip–Tool Contact Zone in Turning of AISI304

ISSN： 1042-6914

Source： Materials and Manufacturing Processes, Vol.29, Iss.5, 2014-05, pp. : 627-633

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Related content

Tool-Chip Friction and Two-Dimensional Numerical Simulation Analysis of High-Speed Milling AISI304

Advanced Materials Research, Vol. 2015, Iss. 1089, 2015-03 ,pp. : 377-380

Trans Tech Publications

Access to resources Recommend Favorite

Cryogenic Turning of AISI 304 Stainless Steel with Modified Tungsten Carbide Tool Inserts

By Dhananchezian M.

Materials and Manufacturing Processes, Vol. 26, Iss. 5, 2011-05 ,pp. : 781-785

Taylor & Francis Ltd

Access to resources Recommend Favorite

Magnetic Damping in Turning of Stainless Steel AISI 304 for the Reduction of Machining Vibration and Tool Wear

Advanced Materials Research, Vol. 2015, Iss. 1115, 2015-08 ,pp. : 100-103

Trans Tech Publications

Access to resources Recommend Favorite

Optimization of Tool Wear Using Coupled RSM-GA Approach in Turning of Stainless Steel AISI 304 with Magnetic Damping of Tool Shank

Advanced Materials Research, Vol. 2015, Iss. 1115, 2015-08 ,pp. : 117-121

Trans Tech Publications

Access to resources Recommend Favorite

Influence of ultrasonic cavitation on surface residual stresses in AISI 304 stainless steel

By Sriraman M.R. Vasudevan R.

Journal of Materials Science, Vol. 33, Iss. 11, 1998-06 ,pp. : 2899-2904

Springer Publishing Company

Access to resources Recommend Favorite