Inverse method for the cooling system design in injection moulding – application to a ‘T-shaped’ piece

Author： Agazzi A.   Sobotka V.   LeGoff R.   Jarny Y.  

Publisher： Taylor & Francis Ltd

ISSN： 1741-5977

Source： Inverse Problems in Science and Engineering, Vol.22, Iss.5, 2014-07, pp. : 707-726

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Related content

A scaffolding architecture for conformal cooling design in rapid plastic injection moulding

By Au K.   Yu K.  

The International Journal of Advanced Manufacturing Technology, Vol. 34, Iss. 5-6, 2007-09 ,pp. : 496-515

Springer Publishing Company

Access to resources Recommend Favorite

A scaffolding architecture for conformal cooling design in rapid plastic injection moulding

By Au K.   Yu K.  

The International Journal of Advanced Manufacturing Technology, Vol. 34, Iss. 5-6, 2007-09 ,pp. : 516-516

Springer Publishing Company

Access to resources Recommend Favorite

Conceptual design support system in a collaborative environment for injection moulding

By Qiu H.   Li C.  

The International Journal of Advanced Manufacturing Technology, Vol. 24, Iss. 1-2, 2004-07 ,pp. : 9-15

Springer Publishing Company

Access to resources Recommend Favorite

A meshless method for predicting two dimensional flow front advancement and its application in injection moulding

By Au C.  

The International Journal of Advanced Manufacturing Technology, Vol. 34, Iss. 1-2, 2007-08 ,pp. : 62-69

Springer Publishing Company

Access to resources Recommend Favorite

A New Method to Design Cam Used in Automobile Heating, Ventilating and Cooling System

By Singh B.  

Journal of The Institution of Engineers (India): Series C, Vol. 93, Iss. 4, 2012-10 ,pp. : 275-286

Springer Publishing Company

Access to resources Recommend Favorite