Experimental Investigation of Machining Parameters during Turning of AISI 316L Stainless Steel Using Nano Cutting Environment

Publisher： Trans Tech Publications

E-ISSN： 1662-7482|2015|787|361-365

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2015, Iss.787, 2015-09, pp. : 361-365

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Modeling and Analysis of Cutting Force in Turning of AISI 316L Stainless Steel (SS) under Nano Cutting Environment

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 766, 2015-07 ,pp. : 949-955

Trans Tech Publications

Access to resources Recommend Favorite

Improved Surface Integrity during End Milling AISI 316L Stainless Steel Using Heat Assisted Machining

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 752, 2015-05 ,pp. : 62-67

Trans Tech Publications

Access to resources Recommend Favorite

Experimental Investigation to Improve Surface Integrity of Biomedical Devices by End-Milling AISI 316L Stainless Steel

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 789, 2015-10 ,pp. : 141-145

Trans Tech Publications

Access to resources Recommend Favorite

Experimental Investigation of Soyabean Oil Based Cutting Fluid during Turning of Hardened AISI 4340 Steel with Minimal Fluid Application

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 813, 2015-12 ,pp. : 337-341

Trans Tech Publications

Access to resources Recommend Favorite

Experimental Study on Electroplastic Effect in AISI 316L Austenitic Stainless Steel

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 792, 2015-10 ,pp. : 568-571

Trans Tech Publications

Access to resources Recommend Favorite