Effect of Geometries of Die/Blank Holder and Punch Radii in Angular Deep-Drawing Dies on DP Steel Formability

E-ISSN： 1662-7482|2015|813|269-273

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2015, Iss.813, 2015-12, pp. : 269-273

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Effect of the Blank-Holding Load on the Drawing Force in the Deep-Drawing Process of Cylindrical and Square Cups

Applied Mechanics and Materials, Vol. 2015, Iss. 760, 2015-06 ,pp. : 379-384

Trans Tech Publications

Access to resources Recommend Favorite

The Influnce of Some Parameters on the Quality of Deep Drawing of Cylindrical Cups without a Blank Holder

Applied Mechanics and Materials, Vol. 2015, Iss. 809, 2015-12 ,pp. : 259-264

Trans Tech Publications

Access to resources Recommend Favorite

Improvement of Formability in Single Point Incremental Forming of DP 1000 Steel by Induction Heating

Applied Mechanics and Materials, Vol. 2015, Iss. 794, 2015-11 ,pp. : 67-74

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Forming Parameters on Springback of Advanced High Strength Steel DP800

Applied Mechanics and Materials, Vol. 2014, Iss. 703, 2015-01 ,pp. : 182-186

Trans Tech Publications

Access to resources Recommend Favorite

Formability Analysis of Steel Sheet by Use of Numerical Simulation

Applied Mechanics and Materials, Vol. 2015, Iss. 736, 2015-04 ,pp. : 80-85

Trans Tech Publications

Access to resources Recommend Favorite