Si Particle Size-Controlled Al-17 Mass% Si Alloy and Tool Wear in Cutting Al-17 Mass% Si Alloy by Polycrystalline Diamond Compact Cutting Tool

Publisher： Trans Tech Publications

E-ISSN： 1662-7482|2015|798|372-376

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2015, Iss.798, 2015-11, pp. : 372-376

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Tribological Behaviour of SiC Particle Reinforced Al-Si Alloy

By Kaur Kamalpreet  

Tribology Letters, Vol. 44, Iss. 1, 2011-10 ,pp. : 41-58

Springer Publishing Company

Access to resources Recommend Favorite

CUTTING PERFORMANCE AND WEAR MECHANISM OF Si3N4-BASED NANOCOMPOSITE CERAMIC CUTTING TOOL IN MACHINING OF CAST IRON

By Zou Bin  

Machining Science and Technology, Vol. 15, Iss. 2, 2011-04 ,pp. : 192-205

Taylor & Francis Ltd

Access to resources Recommend Favorite

Dry Sliding Wear Behavior of Zircon Sand Reinforced Al–Si Alloy

By Kaur Kamalpreet  

Tribology Letters, Vol. 38, Iss. 3, 2010-06 ,pp. : 377-387

Springer Publishing Company

Access to resources Recommend Favorite

The Numerical Simulation of Reinforced Particle Stress Concentration in Al-Si Alloy Rolling

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 719, 2015-02 ,pp. : 55-58

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Particle Size on Tribological Behavior of Rice Husk Ash–Reinforced Aluminum Alloy (AlSi10Mg) Matrix Composites

By Saravanan S. D.   Senthilkumar M.   Shankar S.  

Tribology Transactions, Vol. 56, Iss. 6, 2013-11 ,pp. : 1156-1167

Taylor & Francis Ltd

Access to resources Recommend Favorite