Experimental Analysis of Machining Parameters in WEDM of AISI D3 Steel Using Taguchi Method

Publisher： Trans Tech Publications

E-ISSN： 1662-7482|2015|799|343-350

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2015, Iss.799, 2015-11, pp. : 343-350

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Experimental Investigation of Machining Parameters during Turning of AISI 316L Stainless Steel Using Nano Cutting Environment

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 787, 2015-09 ,pp. : 361-365

Trans Tech Publications

Access to resources Recommend Favorite

Multiple Performance Characteristics Optimization in the WEDM Process of SKD61 Tool Steel Using Taguchi Method Combined with Weighted Principal Component Analysis (WPCA)

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 758, 2015-05 ,pp. : 21-27

Trans Tech Publications

Access to resources Recommend Favorite

Optimization of Machining Parameters of Valve Steel SUH03 (X45CrSiMo10-2) Using Gray Based Taguchi Method

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 813, 2015-12 ,pp. : 376-381

Trans Tech Publications

Access to resources Recommend Favorite

Optimization of Multiple Response Characteristics in the WEDM Process of Buderus 2379 ISO-B Tool Steel Using Taguchi-Grey-Fuzzy Logic Method

By  

Applied Mechanics and Materials, Vol. 2016, Iss. 836, 2016-07 ,pp. : 185-190

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Cutting Parameters on Feed Force in Machining AISI 1018 Steel

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 813, 2015-12 ,pp. : 299-303

Trans Tech Publications

Access to resources Recommend Favorite