Publisher： Trans Tech Publications
E-ISSN： 1662-7482|2015|799|581-584
ISSN： 1660-9336
Source： Applied Mechanics and Materials, Vol.2015, Iss.799, 2015-11, pp. : 581-584
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.
Abstract
It’s necessary to calculate and analyze the strength of the pump impeller for the safe operation of the pump. In this paper, the impeller strength of a two-way full-adjust horizontal axial-flow pump in a domestic pump station under forward pumping conditions was calculated by using the unidirectional fluid-structure interaction method; it means loading the blade surface water pressure calculating from CFD software CFX as structure surface loads to the blade, and then calculating the strength of the impeller using finite element software ANSYS ; the strength of the impeller was calculated under different blade rotating angle conditions. Through the calculation, we has got static stress and deformation distribution in the impeller. The results show that under each blade rotating angle, the maximum static stress always increases with lift increasing; the maximum static stress occurs at the junction of the blade and hub; the stress concentration also occurs in there prone to cause fatigue failure; maximum deformation of the blade occurs in the leading edge close to the rim; the maximum static stress is far less than yield strength of the material that the static stress can not cause cracks.
Related content
An Investigation of the Vortex in a Submersible Axial Flow Pump Impeller
Applied Mechanics and Materials, Vol. 2015, Iss. 741, 2015-04 ,pp. :
Access to resources
Recommend
Kinematic Analysis of Swash Plate Axial Piston Pump Based on Adams Simulation
Applied Mechanics and Materials, Vol. 2015, Iss. 741, 2015-04 ,pp. :
Modal Analysis Based on Fluid-Structure Interaction of Axial Flow Rotor
Applied Mechanics and Materials, Vol. 2015, Iss. 799, 2015-11 ,pp. :