Hot Deformation of Al - 4.5 Mass % Mg Alloy Sheet

Publisher： Trans Tech Publications

E-ISSN： 1662-8985|2014|1063|126-129

ISSN： 1022-6680

Source： Advanced Materials Research, Vol.2014, Iss.1063, 2015-01, pp. : 126-129

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Deformation behavior of an Al–Cu–Mg–Mn–Zr alloy during hot compression

By Li Yao   Liu Zhiyi   Lin Lianghua   Peng Jiangtao   Ning Ailin  

Journal of Materials Science, Vol. 46, Iss. 11, 2011-06 ,pp. : 3708-3715

Springer Publishing Company

Access to resources Recommend Favorite

The effect of homogenization on the recrystallization of an Al-Mn-Mg alloy sheet

By Aghaie-Khafri M.  

Journal of Materials Science, Vol. 40, Iss. 5, 2005-03 ,pp. : 1135-1139

Springer Publishing Company

Access to resources Recommend Favorite

Formability of a high-strength Al–Mg6.8 type alloy sheet

By Romhanji E.   Popovic M.   Glisic D.   Milenkovic V.  

Journal of Materials Science, Vol. 33, Iss. 4, 1998-02 ,pp. : 1037-1042

Springer Publishing Company

Access to resources Recommend Favorite

Characteristics of steady state deformation of an Al-0.1 Mg alloy at low temperatures

By Huang Y.  

Journal of Materials Science, Vol. 48, Iss. 13, 2013-07 ,pp. : 4484-4491

Springer Publishing Company

Access to resources Recommend Favorite

Plastic deformation behavior of ultrafine-grained Al–Mg–Sc alloy

By Kumar N.   Komarasamy M.   Mishra R.  

Journal of Materials Science, Vol. 49, Iss. 12, 2014-06 ,pp. : 4202-4214

Springer Publishing Company

Access to resources Recommend Favorite